Skip to content
View mobile menu
Shop Our Categories
SHOP BY CATEGORY
BOATS 4 SALE
ODDS & ENDS
PROP SEAL INSTALL
Nav Menu 3
Nav Menu 4
Nav Menu 5
Nav Menu 6
Nav Menu 7
Nav Menu 8
Terms & Conditions
Mon-Fri 9am-5pm PST
1" Rudder Stuffing Box Round Flange
New design. Made from 6061-T6 Aluminum that is machined finish.
Sealed bearing design (just like our billet prop shaft log seals). No more housings to wear out!!! The prop shaft rides on the bearing.
Our new rudder stuffing box has a standard 4 1/16 round mounting flange. So it is a direct replacement for your older style stuffing box. I did not put in mounting holes because every hull is different and has a variety of hole sizes and patterns. All you have to do is transfer punch the existing hole locations in your hull to the rudder box and drill the size you need.
Fits all standard 1 1/2 diameter thru hull holes. I left the 1 1/2 diameter section that goes thru the bottom of your hull long (1 3/4 long) to accommodate any hull thickness. You will have to trim to fit.
Overall height of stuffing box inside the boat is 2 1/8
Starting from the top of the stuffing box to the bottom features a snap ring for safety to help retain the 1 sealed bearing that is bored a few thousands larger than your rudder shaft.
Next is an ample sized grease reservoir which is filled by the grease zert located on the outside of the rudder box housing.
Two double lip grease cup seals are lightly pressed in as a second barrier to keep water out. The first water barrier is a 1/8 diameter o-ring that is below the grease cup seal.
V-DRIVE 1" RUDDER QUADRANT SMOOTH
TOP RUDDER BEARING 1"
1 1/8" Rudder Box Rebuild Kit
1 1/8" Aluminum Split Safety Collar
Sale Price: $29.99
1" Aluminum Split Safety Collar
TOP RUDDER BEARING 1 1/8"
TEFLON WASHER 1"
1" Rudder Box Rebuild Kit
Sale Price: $29.99