1 1/8" Prop Shaft Seal
1 1/8" Prop Shaft Seal

Our Price: $99.99

Product Code: D21-002


Made from 6061-T6 aluminum with a machined finish. They are approximately 3" diameter by 2 7/8" long. There is a lightly pressed in 2 1/2" diameter double sealed bearing with the inside diameter bored to 1.128" (to easily slip over your prop shaft). It held in the aluminum housing by a snap ring for safety.
Also inside the aluminum housing is two double lip cup seals to keep the water out and a grease zert on the outside body to grease the seal. A standard size 1 3/4" hose fits from the rear, I also added rounded grooves to help the hose clamp bite into the housing and not slip off.
With this design there will be no more prop shaft wear of bushings to replace because it rides on a bearing.
Also, while replacing your prop shaft seal, please check out our 1 3/4" Marine Grade Rubber Hose and 1 3/4" 100% Stainless Steel T-Bolt Clamps.

Please read "Installation and Maintenance" section.

Copyright ©  . All Rights Reserved.

Built with Volusion.